User's Manual

9
After plugging into a SIM card, the phone will automatically check SIM card for availability, then
the display screen will indicate the following prompts in sequence:
1) “Enter phone lock password” ―― if you have started up the phone lock (default password:
“1234”)
2) “Enter SIM 1/2 PIN” ―― if you have started up the SIM card 1/2 lock.
3) “No service” ―― it represents the register network failure, and you cannot make a call at such
time.
4) “Emergency Call” ―― it allows to call 112.
5) “Search” ―― the phone is searching a network, until it finds out a suitable service network.
6) The screen displays the network operator name – it represents the network register success.
If only SIM 1 card is installed and the current mode is “SIM card 1 only”, the screen will display
the name of SIM card 1 provider only and that “SIM card 2 is off”; if only SIM card 2 is installed,
the screen will display vice versa. If only SIM card1 is installed and the current mode is “two cards
on”, the screen will display the name of SIM card 1 provider only and that “Please insert SIM card
2”; if only SIM card 2 is installed, the screen will display vice versa.
 Switch off:
To shut down your MAXX phone, long press ON/OFF key, and after the screen displays the
power off animation, the cell phone will shut down. Please do not shut down the phone directly
by dismantling the battery, if done so, it is likely that you may damage the SIM card and may
lose some information.
 Making a call:
• Enter the phone number in standby status, and press the calling key to call. If you want to
hang up or cancel the call, press the hang up/cancel key. When the phone is connected, yo
u
can see the holding time on the screen.
• Use the phonebook to make a call: Search the name/phone number saved in the phonebook,
and press the calling key to call.
• Redial the latest phone number: Press the calling key in standby status to search the latest list
of phone numbers or names. Roll over to the number or name of SIM 1/2, then
p
ress the
calling key.
 Adjusting the receiver volume:
During a call, you can press the up or down direction key to adjust the receiver volume.
 Answering a call:
When there is an incoming call, it will indicate in a mode of ring, vibration, vibrate and ring o
r
ring after vibration according to the setup of cell phone.
To answer a call, press the calling key.
To reject a call, press on/off key.
If you have applied for calling number identification service, the calling number will show on
the screen. If this number is already stored in the phonebook, the corresponding name of this
number will be shown on the screen.
If the call is to SIM card 1, “SIM 1 incoming” will be displayed in front of the number or name.