User's Manual

6
2.4
2.42.4
2.4 Battery
BatteryBattery
Battery
The battery was charged about 50% electrical power, it is available to use immediately
after the phone is unpacked. For the first three times, the power must be run out of, and then
the battery should be fully charged to use, thus the battery can supply in the best service
condition.
1. Remove and install the battery
 Dismantle by following procedures:
Slide the cover of battery downward to the bottom of the mobile phone, and then ①
remove the cover.
Lift the bottom of battery upward and remove it from battery box.②
Warning: power off before removing the battery. When the phone is power on or
connected to external power supply, it is forbidden to remove the battery, or the SIM
card and phone would be damaged.
 I
nstall by following procedures:
Align the metal contact point of battery with that of battery box, and snap the battery in
the box and press the battery downward until it is installed well.
2. Charge
 Insert the charger on the supply.
 Connect the right end of charger to the side port of mobile phone.
 After connection, the screen of mobile phone displays “The charger was connected”,
and it is charging, the battery icon shows the process of charge; if the phone was power off,
the screen will show the process of charge dynamically.
 In low battery state, overusing the mobile phone will cause low voltage, and the phone
enter low voltage lock mode and can’t power on normally. Charge the battery, and the battery
enter precharge mode process (about ten minutes); after the voltage is rose, the phone can be
power on normally.
 In the power on state, when the power indicator in the icon area is full and doesn’t