Instruction manual

Introduction.
Tools required.
Pozidrive
Screwdriver
Saw
Trestles
Leather
Faced
Gloves
Silicone
Sealant
& Gun
4 & 5mm
Allen
Keys
Pop
Riveter
& 3/16”
Rivets
Tape
Measure
13mm
Socket
Wrench with
Extension
10mm,
12mm &
13mm
Spanners
Herringbone
Systems Only
The following tools and equipment are advisable to complete the tasks laid out in this manual.
Suitable alternative tools may be used.
Document Index.
1 Installation Requirements
1.1 Health & Safety
1.2 Model definitions
1.3 Heater Suspension
1.4 Wall Mounting
1.5 Herringbone systems
1.6 Clearance to Combustibles
1.7 Gas Connection & Supply Details
1.8 Electrical Connections
1.9 Ventilation Requirements
1.9.1 Unflued Radiant Heater (Type A)
Mechanical Ventilation
Natural Ventilation
1.9.2 Flued Radiant Heater
Mechanical Ventilation
Natural Ventilation
1.10 Flue & Combustion Air Inlet
1.11 Technical Details
2 User and Operating Instructions
2.1 To Start Heater
2.2 To Switch off Heater
2.3 Routine Maintenance Between Service Intervals
2.4 Frequency of Servicing
and attention is required to ensure that working
at height regulations are adhered to at the
mounting heights specified.
PLEASE READ this document prior to
installation to familiarise yourself with the
components and tools you require at the various
stages of assembly.
All Dimensions shown are in mm unless
otherwise stated.
The manufacturer reserves the right to alter
specifications without prior notice.
Welcome to the new range of high efficiency
AmbiRad Vision radiant tube heaters. Local
regulations may vary in the country of use and
it is the installers responsibility to ensure that
such regulations are satisfied
All installation, assembly, commissioning and
service procedures must be carried out by
suitable qualified competent persons to the
statutory regulations in the country of use.
When assembling, installing, commissioning
and servicing is undertaken on radiant tube
heaters specified in these instructions, due care