Owner manual

ACN-LS
©2014, Ambient Recording GmbH
8
7. Setup Menu Diagram
When entering a menu, the active parameter setting is highlighted.
MAIN DISPLAY, showing time code, frame rate, sync rate, jam mode, network channel, battery status
↓ push select switch down to enter main menu and to select options, toggle left/right to navigate
↓
GEN
↓
JamTC ↔ Edit ↔ Offset
↓
JamTC:
AUTO ↔ OFF ↔ manual/once
↓
Edit:
HH:MM:SS:FF
↓
Offset:
+/- 00.05 frames
↓
UB
JamUB ↔ Edit-UB ↔ EXIT
↓
JamUB:
normal ↔ manual ↔ insert
Edit-UB:
00:00:00:FF
EXIT:
back to main menu
↓
SLATE
↓
SOURCE ↔ MODE ↔OFFSET ↔ SENS
↓
SOURCE:
GEN ↔ LTC ↔ LTC-VARI ↔ ACN ↔ MTC
↓
↓
MODE:
DIGITS ↔ FLASH-LED
DIGITS
CLAPTIME ↔ UB+CLAPTIME ↔ NO CLAPTIME
FLASH-LED
OFF ↔ CLAP FLASH ↔ CLAP
*
SECONDS
OFFSET
+/- 00.05 frames
↓
SENS
TILT ↔ BRIGHTNESS
TILT
On ↔ Off
BRIGHTNESS
Man ↔ Low ↔ Med ↔ High
↓
TC
↓
FPS ↔ MTC ↔ Level
↓
FPS
FPS: 23.976 ↔ 24 ↔ 25 ↔ 29.97 ↔ 30 ↔ 29.97D ↔ 30D
↓
MTC
MTCout ↔ MIDI>LTC ↔ LTC>MIDI
↓
SYS
↓
Config ↔ INFO ↔ Factory reset
↓
Display ↔ USB ↔ BAT
↓
Display:
Brightness: 0…↔5↔…10
↓
AutoOff: never ↔ 5sec ↔ … ↔ 5min
↓
USB
USB: MTC ↔ COM
↓
BAT
Battery type: Li ↔ Alk ↔ NiMH
↓
INFO: displays device information: serial no., firmware version, mac address
↓
Factory Reset: loads default settings