User's Manual

Verify the indoor and outdoor temperature match closely with the console

and sensor array in the same location (about 5 to 10’ apart). The sensors

should be within 2°F (the accuracy is ± 1°F). Allow about 30 minutes for

both sensors to stabilize. The temperature can be adjusted or calibrated

later to match each other or a known source.

3. Remote Sensor Installation

If you purchased the outdoor sensor for this console (optional):

It is recommended you mount the remote sensor on a north facing wall, in

a shaded area. Direct sunlight and radiant heat sources will result in

inaccurate temperature readings. Although the sensor is water resistant,

it is best to mount in a well protected area, such as under an eve. Use a

screw or nail (not included) to affix the remote sensor to the wall, as

shown in Figure 3.

Figure 3

4. Console Operation

Note: The console has four buttons for easy operation: MIN/MAX/-

button, CLEAR/ADJUST button, CHANNEL/+ button and LIGHT button.

4.1 Min/Max Mode

The Min/Max mode displays the minimum and maximum temperature and

humidity (since reset of the unit) for the indoor, remote channel 1

through

8 sensors.