User's Manual

Figure 9

Channel Number: The WS-12 supports up to eight transmitters. To set each channel number

(the default is Channel 1), change Dip Switches 1, 2 and 3, as referenced in Table 1.

Temperature Units of Measure: To change the transmitter display units of measure (°F vs.

°C), change Dip Switch 4, as referenced in Table 1.

DIP SWITCH

1 2 3 4

FUNCTION

DOWN DOWN DOWN --- Channel 1

DOWN DOWN UP --- Channel 2

DOWN UP DOWN --- Channel 3

DOWN UP UP --- Channel 4

UP DOWN DOWN --- Channel 5

UP DOWN UP --- Channel 6

UP UP DOWN --- Channel 7

UP UP UP --- Channel 8

--- --- --- DOWN °F

--- --- --- UP °C

Table 1

2. Insert two AAA batteries.

3. After inserting the batteries, the remote sensor LED indicator will light for 4 seconds, and

then flash once per 60 seconds thereafter. Each time it flashes, the sensor is transmitting

data.

4. Verify the correct channel number (CH) and temperature units of measure (°F vs. °C) are

on the display, as shown in Figure 10.