User's Manual

2.4 Display Console Set Up

1. Move the remote thermo-hygrometer(s) about 5 to 10’ away from the display console (if

the sensor is too close, it may not be received by the display console). If you have more

than one transmitter, make sure they are all powered up and transmitting on different

channels.

2. Remove the battery door on the back of the display, as shown in Figure 4. Insert four AA

(alkaline or lithium)) batteries in the back of the display console.

The display will beep once and all of the LCD segments will light up for a few seconds

to verify all segments are operating properly. The console will cycle through a spectrum

of colors.

Note: The character contrast is best from a slightly elevated viewing angle.

Figure 4

3. Replace the battery door, and fold out the desk stand and place the console in the upright

position.

The console will instantly display indoor temperature, humidity, barometer, tendency,

date and time. The remote temperature and humidity will update on the display within a

few minutes on the appropriate channel.