User's Manual

12. Outdoor 1 (channel 1) humidity low alarm

Note: To prevent repetitive alarming of temperature, there is a 0.9 °F tolerance band. For

example, if you set the high alarm to 80.0 °F and silence the alarm, the alarm icon will continue to

flash until the temperature falls below 79.1 °F, at which point, the alarm will reset and must

increase above 80.0 °F to activate again.

Note: To prevent repetitive alarming of humidity, there is a 4% tolerance band. For example,

if you set the high alarm to 60% and silence the alarm, the alarm icon will continue to flash until

the humidity falls below 56%, at which point, the alarm will reset and must increase above 60% to

activate again.

6.4 Alarm and Command Key Beeper ON/OFF Mode

The beeper can be silenced for both alarms and key strokes.

In normal mode, press and hold the ALARM key for five seconds to toggle the beeper on or off

(depending on the current setting).

The BUZZON (beeper on) or BUZZOFF (beeper off) icon will appear in the time area for three

seconds. Press and hold the ALARM button again for five seconds to toggle the BUZZON or

BUZZOFF command.

7 Other Console Features

The following section describes additional features and display icons.

7.1 Weather Forecasting

Note: The weather forecast or pressure tendency is based on the rate of change of barometric

pressure. In general, when the pressure increases, the weather improves (sunny to partly cloudy)

and when the pressure decreases, the weather degrades (cloudy to rain).

The weather forecast is an estimation or generalization of weather changes in the next 24 to 48

hours, and varies from location to location. The tendency is simply a tool for projecting weather

conditions and is never to be relied upon as an accurate method to predict the weather.

7.2 Weather Icons

The following icons are displayed based on the rate of change threshold defined in Section 7.4.