User manual

6. Indoor Humidity Low Alarm. Press the SET button again and the indoor humidity alarm

will begin flashing. Press the + button or MIN/MAX button to change the indoor humidity

alarm setting.

To set the indoor humidity alarm, press the ALARM button while the indoor humidity is

flashing, and the alarm icon LO AL will turn on. To turn off the alarm, press the ALARM

button again, and the alarm icon will turn off.

When the indoor humidity exceeds the alarm setting, the alarm will sound.

7. Indoor Temperature Low Alarm. Press the SET button again and the indoor temperature

alarm will begin flashing. Press the + button or MIN/MAX button to change the indoor

temperature alarm setting.

To set the indoor temperature alarm, press the ALARM button while the indoor temperature

is flashing, and the alarm icon LO AL will turn on. To turn off the alarm, press the

ALARM button again, and the alarm icon will turn off.

When the outdoor temperature exceeds the alarm setting, the alarm will sound.

Press the SET button again to exit the high alarm setting mode.

5.3.2 Cancelling the Alarm While Sounding

To cancel an alarm that is sounding, press any key and the alarm will be silenced. Otherwise, the

alarm will time out in 120 seconds.

When a weather alarm is triggered (all alarms except for the time alarm), the alarm will also turn off if

the alarm set point is no longer exceeded.

After an alarm is activated, the icon will flash for three hours but the alarm will not continue to sound

to avoid repeated triggering of the same alarm value (nuisance alarms).

After three hours, if the alarm set point is exceeded, the alarm will sound again.

5.4 Min / Max Mode

To enter the Min/Max mode from the normal mode, press (do not hold) the MIN/MAX button. The

backlight turns on and the console beeps. The maximum values and the MAX icon will be displayed.

To view the minimum values, press the MIN/MAX button again and the MIN icon will be displayed.

To exit the min/max mode, press the MIN/MAX button again.

The following section outlines resetting min/max values. The process is identical for minimum and

maximum settings (depending on which mode is displayed).

The min/max modes can be exited at any time by either pressing the HISTORY button or waiting for

the 30-second time-out to take effect. You can skip over any setting by pressing the SET button

again.

5.4.1 Max Mode

After entering the maximum display mode (reference Section 5.4), press the + button to display the

maximum values and associated time and date stamp it occurred as referenced in Table 1. While the