User's Manual

User Manual
SM3000 OEM module
7 Compliance(s)
7.1 United States and Canada (FCC and IC)
The SM3000 SmartPoint OEM module complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation. This is described in
Part 15.19 (a)(3) and (5).
This Class B digital apparatus complies with Canadian ICES-003. Cet appareil numerique del la classe B est
conforme al norme NMB-003 du Canada.
This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance wit the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try and correct the interference
by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and the receiver.
– Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
– Consult the dealer or an experienced radio/TV technician for help
WARNING: Any modifications to the units, unless expressly approved by the party responsible for
compliance, could void the user's authority to operate the equipment.
A copy of all FCC and Industry Canada certificates can be obtained by contacting the support department:
[e-mail].
Modular requirements overview
Own RF shielding
The module has an 18 x 18 x 4mm tin-plated brass shield that covers the essential radio components. It is
located near the middle of the PC-board as shown in the following photo.
21/27 Ambient Systems B.V.