User Manual

Model: GW3030v2
Revision P1A
USER MANUAL
Gateway GW3030 v2.0
Ambient Systems B.V.
Page 12 of 15
Demmersweg 66 • 7559 BN Hengelo • The Netherlands
T: [phone] • F: [phone] • www.ambient-systems.net
KvK: 08122911 • VAT NL: 81297625381
CHECK.TRACK.TRACE.
7 Communication port options
By default, the Gateway GW3030 v2.0 uses the USB port to communicate with a PC, however, the device is
also equipped with a RJ11 socket for RS232 communication.
!! By default, the Gateway GW3030 v2.0 uses the USB port for communication
The communication port to use can be selected in the Network::Gateway driver. The selection is accepted
after a device reset (System::Reset:Reset). Until a reset the current active port remains active.
!! Only one of the communication ports is operational at a time. The used communications port can only be
selected through the current active port
8 DDI Drivers
The following DDI drivers are installed on the Gateway GW3030 v2.0:
 DDI(0:0) System::DDI
 DDI(0:1) System::Echo
 DDI(0:2) System::Version
 DDI(0:3) System::FileSystem
 DDI(0:4) System::Reset
 DDI(0:5) System::LED
 DDI(0:6) System::Power
 DDI(0:8) System::SwitchMode
 DDI(0:13) System::KeyManager
 DDI(3:1) Network::DNCP
 DDI(3:2) Network::Gateway
 DDI(3:3) Network::DataDissemination
 DDI(3:4) Network::InfrastructureNetInfo
 DDI(3:5) Network::RapidClient
 DDI(3:6) Network::DNCPAccess
 DDI(3:8) Network::SmartPointQueue
The support section on the Ambient website contains detailed descriptions of these drivers and their
configuration.
!! The Gateway GW3030 v2.0 uses newer versions of DDI drivers compared to the GW3030 v1.x. Please
make sure you use the latest DDI XML’s in Ambient Studio