Specifications
Please see the explanation below these are the times the heater operates in
comfort mode:
• P1 3.00pm – 11.00pm
• P2 7.00am – 12.00(Midnight)
• P3 7.00am – 11.00pm
• P4 5.00am – 7.00am then 9.00pm – 11.00pm
• P5 7.00am – 9.00am then 10.00pm – Midnight
• P6 7.00am – 9.00am then 9.00pm – 11.00pm
• P7 6.00am – 4.00pm
• P8 Frost Mode Only
• P9 Constant 24 hours
N.B When choosing a program For Example P4. The unit will heat on
comfort temperature 5.00am – 7.00am and then again at 9.00pm –
11.00pm. From 11.00pm – 5.00am it will be on economic setting.
From 7.00am – 9.00pm it will be on Anti Frost setting.
All these pre-settings can be altered with the method
mentioned in chapter 7 and will be kept in memory as
new settings.
If you want to return to a factory pre-setting, please operate as follows:
a. switch off the unit with power switch
b. Press the button continuously for about 7 seconds, the unit will
call back the factory pre-setting. Then you can release the
button .
10. Other notes：
(1) The screen will become dull after 1 minute when no buttons are pressed.
It will extinguish after 1 minute if you didn’t press any button. It will light
up if you press any button.
(2) Unit has a button lock function. The buttons will be locked ( ) after 1
minute if none of the buttons are pressed.
To unlock: press and at same time for 3 seconds.
(3) Time will reset to 00:00 if you unplugged unit or cut off the power.
(4) This heater includes an overheat protection system that shuts off the
heater when parts of the heater are getting excessively hot.
MAINTENANCE
1. Always remove the plug from the socket-outlet and allow the heater to cool
down before clean it.
2. Wipe the exterior surface of the heater occasionally with a soft damp cloth
(not dripping wet) and dry the exterior surface before operating the heater.
WARNING:
Do not immerse the heater in water.
Do not use any cleaning chemicals such as detergents and abrasives.
Do not allow the interior to get wet as this could create a hazard.
3. Light dirt accumulation may be removed from the heater with a soft dry cloth.