User manual

7. Select “Specify a location” and click “Browse”. On the windows information dialog, double-click the

“D:\WL1100B-AP\USB_DRIVER” folder icon from the list and Windows

98 will automatically enter the

path. Then click “Next”.

8. Windows

98 will then acknowledge that it has found the appropriate driver and click "Next".

9. Windows

98 will install the driver “Access Point USB Device Driver”. As the driver files are being

copied to the appropriate location, you will be prompted to insert the Windows

98 CD.

NOTE: You must insert the Windows

98 CD as the driver installation requires special files that will not be

available, even if you have stored a copy of Windows

98 source on your hard drive.

10. After Windows

98 has finished installing the appropriate files, click “Finish”.

11. From the Control Panel, double-click the “System” icon.

12. From the “Hardware” menu, please select the “Device Manager” tab. And check the “AccessPoint”

device whether it works fine.

3-1-2 Installing WL1100B-AP USB Driver For Windows

2000

1. Please boot your PC into Windows

2000.

2. Plug the two sides of the USB cable into the USB slots of WL1100B-AP and your PC.

3. Windows

2000 will automatically detect the WL1100B-AP and prompt you to install the necessary driver.

Make sure that the Setup Utility CD is inserted in the CD-Rom drive and click “Next” on the Found New

Hardware Wizard screen to proceed.