User manual

-17-
Caveat
n Due to WinCE's nature of the first application at power-on resuming to that at power-off, if
you are stuck at the utility program, you may use the PDA's reset bottom to terminate it.
And activate it again when needed.
n If your wireless connection to AP might disconnect, you can reset and force a connection
request by going to utility program, then select "Configuration", check parameters, then
select "Connect" to force a re-scan.
n If your device roams to a new AP which is in a different subnet, you may need to remove
and re-insert the Wireless LAN Compact Flash Adapter to force an execution of "release
and renew" of an re-assignment of IP address in a DHCP Access Point environment.