Installation Guide

2 of 3

Step 5

Remove the cover plate and slide it to the back of

the wire cover tube. Now place the unit over the

tapered bushings installed in Step 4.

Securely hand-tighten each of the four set screws on

the bottom of the tubes.

Remove wire from slot in the end of the horizontal

tube. Position the wire from the rail and the wire from

the junction box to allow for connection. (Fig 5)

Splice the wires using the connectors provided and

place them inside the junction box. Cover the box

with the plate and secure with screws provided.

Step 6

The towel rails must be connected to either

an on/off switch (like a light switch) or a

7 day/24 hour programmable timer. (Fig 6)

Make sure one is provided for at installation.

The towel warmer will not perform if a timer

with a shorter cycle is used.

See wiring diagram below:

Please note: Due to the low

power requirements, and

the built-in thermostat which

maintains the unit at a safe

temperature, these units

can be left on all the time

without much energy

consumption. The longer the

unit is on the more

effectively it will perform.