User guide

296
Control (UI) Default Value Function
Revert N/A Reloads the LiveGroup from its current source, thus discarding
any changes made while it was unlocked. Revert is only
available when a source has been set.
Publish... N/A Opens the Publish LiveGroup dialog for publishing the
parameters and contents of the LiveGroup node as a LiveGroup
source file or asset. This leaves the node in an editable state for
further changes.
Publish and Load... N/A Opens the Publish and Load LiveGroup dialog for publishing
the parameters and contents of the LiveGroup node as a
LiveGroup source file or asset, and for loading the published
source file or asset. This sets the node to be non-editable and
locks the node against further changes.
Convert to Group N/A Converts the LiveGroup node to a Group node.
Other | Show
Parameters
N/A Opens the Parameters tab.
LiveGroupStack
This is a convenience node for managing a stack of nodes of the same type. When initially created, it is typeless. Drag
a node into the list to define the type of the stack.
NOTE: This node is a live reference to an externally stored file specified using the source parameter. As
such, its internal nodes are read-only. See also LiveGroup on the previous page.
Control (UI) Default Value Function
[stack contents] none Contains the list of nodes to manage.
N/A Brings up a searchable list to aid in selection.
/
N/A
Hides all nodes. Unhides all nodes.
[Right-click menu]
5 NODES L-Q | LIVEGROUPSTACK