User guide

244
Control (UI) Default Value Function
image > rawData: disabled
colorspace auto Select the colorspace for the file on disk. Upon
load, the image sequence is converted from this
colorspace to Katana's native floating-point linear
colorspace. The default value, auto, means
Katana tries to determine the bit depth from the
file header and the colorspace from the file
name. If Katana gets this wrong or the file is not
named in a standard way, you can use this
control to force Katana to assume the image data
is in the selected colorspace and bit depth.
You can also use this control to avoid the
colorspace conversion entirely by specifying lnzf
or ncf, which indicate that the file is already
linear. Bear in mind, however, that most image
processing operations in Katana presume linear
input data. The results of image processing
operations in Katana are not defined, tested, or
supported for non-linear image data. All
operators have been implemented assuming
input images are linear.
image > isProxy: enabled > fullResFrame
[resolution] Dependent on Project Settings When isProxy is enabled, you can use this
control to select the resolution for the full-
resolution image.
left timing.missingFrameBounds.left
bottom timing.missingFrameBounds.bottom
width timing.missingFrameBounds.width
height timing.missingFrameBounds.height
timing
4 NODES I-K | IMAGEREAD