User Manual

11
EN
• Adjust the position of the slide using the X and Y translation controls
(O, R).
• Look into the left eyepiece (X/Y), rotate the fine focus knob (Q) slowly
until the image is clear. Adjust the position of the slide if needed.
CAUTION
Risk of electric damage! Never force the adjustment
knobs (P), (Q) and, (V) to turn further once the knob is already restrained
from turning. It may cause friction and scratch the lenses.
• The condenser (G) is adjusted to focus the light unto the specimen.
Tinker around with the condenser (G)’s vertical knob (V), diaphragm
(W), and adjustment screws (Z) to achieve the sharpest image.
NOTICE
The condenser diaphragm (W) gathers the available light
and concentrates it to illuminate over the specimen with uniform intensity.
S
• Look into the right eyepiece (X/Y), rotate the diopter adjustment (K)
until the image is clear.
• Look into both eyepieces (X/Y), adjust the distance between the
adjustable eyepiece housing (L) until the two images merge into one.
• Rotate the nose piece (A) to the next objective lens, increasing in
magnification power. Re-adjust the focus using the fine focus knob
(Q) if needed.
• After using the microscope, remove the slide from the stage (F), take
off the eyepieces (X/Y) and place the eyepiece covers (J) on.
• Turn to minimum the adjustment wheel (U).
• Switch off (T) and disconnect the adapter (AB) from the power outlet.
• Clean the work area and dispose of the used specimens.