Operator`s manual

OperatOr’s Manual
AMAZING MACHINERY 3807 OLD TASSO RD. NE  CLEVELAND, TN 37312  PHONE: [phone] FAX: [phone]
page 5
MOVING, STORAGE
 Place machine in covered area when not in use to protect from elements.Protect machine from
freezing in cold temperatures by storing in a heated location.
WINTERIZING
 Direct Drive Machines with Water Tank: To protect the machine from freezing temperatures while
storing or transporting, pour antifreeze into partially full (1/8 full or less) water tank. Remove water
nozzle from end of wand and carefully insert wand into opening of water tank. Start machine and run
until antifreeze water mixture has circulated throughout the machine returning back to the water tank.
ENGINE MAINTENANCE
 Every time (before start): Check oil level.
 First 8 hours: Change oil with SAE 30W High-Detergent Oil.
 Every 25 hours: Change oil if operating under heavy load or high ambient temperature.
Service air cleaner pre-cleaner.
 Every 50 hours: Change oil. Clean and inspect spark arrester if equipped.
 Every 100 hours: Service air cleaner cartridge, replace oil filter (if equipped),
Clean oil cooler (if equipped), Clean cooling system.
PUMP MAINTENANCE
 Fill crankcase to dot on oil gauge window per specifications with the specific oil created by the
pump manufacturer (i.e.
General Pump Oil). Ensure the right oil for specific pump as it may vary.
 Change oil after 40 Hour Break-in Period.
 Change oil every Three Months or at 500 Hour Intervals thereafter.
Maintenance Instructions
 All Amazing Machinery machines have the
unloader correctly set at the the factory. Setting
an unloader is a difficult job without the proper
equipment and training. Should the need arise
to change the unloader settings, please contact
your local pressure washer dealer.
UNLOADER ADJUSTMENT
CHANGING THE UNLOADER SETTINGS WITHOUT THE PROPER
EQUIPMENT AND TRAINING MAY RESULT IN NON-WARRANTY
DAMAGE TO THE PUMP.
�
WARNING
Pulsar
Unloader