Operator’s Manual TAG-A-LONG & AUTO DETAILING PKG. 5.5hp, 11hp & 13hp Gas Engine READ THIS MANUAL This manual contains important information for the use and safe operation of your AMAZING MACHINERY™ machine. FAILURE TO READ THIS MANUAL AND FOLLOW ITS INSTRUCTIONS PRIOR TO OPERATING OR ATTEMPTING ANY SERVICE OR MAINTENANCE PROCEDURE COULD RESULT IN SERIOUS INJURY OR DEATH TO YOU OR OTHER PERSONS; ALSO DAMAGE TO THE MACHINE OR TO OTHER PROPERTY. AMAZING MACHINERY 3807 OLD TASSO RD.
Operator’s Manual Page Table of Contents Section 1 Operator’s Manual Unpacking....................................................................2 Safety Instructions and Warnings.............................3 Operating Instructions...............................................4 Section 2 Parts and Service Manual Maintenance Instructions...........................................5 Parts Diagram.............................................................6 Plumbing Diagram.
Operator’s Manual Page Safety Guidelines � WARNING READ THIS FIRST! Failure to read and observe all WARNING statements could result in severe bodily injury or death, possible injury to other persons, damage to machine or other property. DO NOT operate this machine in areas where open flames are not permitted. DO NOT store or use combustible materials on or near this machine. Use this equipment only in well ventilated areas.
Operator’s Manual Page Operating Instructions LOCATION GUIDELINES Locate the machine on a solid and level surface so that engine and pump crankcase oil lubricate components properly. Avoid areas where water can build up in the working area. Possible injury can occur caused by the surface becoming slippery from water build up. Locate the machine in a well-ventilated area and away from flammable materials or fumes. Be sure ventilation warnings are observed.
Operator’s Manual Page Maintenance Instructions MOVING, STORAGE Place machine in covered area when not in use to protect from elements.Protect machine from freezing in cold temperatures by storing in a heated location. WINTERIZING Direct Drive Machines with Water Tank: To protect the machine from freezing temperatures while storing or transporting, pour antifreeze into partially full (1/8 full or less) water tank.
Operator’s Manual Page Parts Diagram 8 5 7 6 4 1 2 See page #8 3 Ref.# Part # 1 (not shown) (not shown) 2 3 3 3 180-00390-01 620-00001-01 170-00011-01 180-00030-01 206-00048-01 206-00002-02 206-00004-03 Plate,cold water skid Big Wheel kit, 4’x54” Wheel,for Big Wheel kit,#08813 Forklift Tine Engine,gas, 5.
Operator’s Manual Page Plumbing Diagram 1 7 4 3 5 2 6 10 8 9 Ref# 1 1 1 1 1 1 1 1 2. 3. 4. 5. 6. 7. 8. 9. 10. AMAZING MACHINERY Part# Discription Qty 270-00001-01 270-00001-02 270-00001-03 270-00001-04 270-00002-01 270-00002-02 270-00002-03 270-00002-04 554-00006-02 065-00002-01 275-00001-01 552-00004-03 284-00001-01 270-00038-01 552-00003-03 554-00007-03 020-00005-01 Nozzle,water,#3.5, 0° Quick Connect (5.5hp &13hp) Nozzle,water,#3.5, 15° Quick Connect (5.
Operator’s Manual Page Comet LWD Pumps all 5.5hp & 6.5hp units 1 Ref.# Part # Description 1 220-00094-01 LWD 3020G Triplex Plunger Pump Complete (5.5hp) 1 221-00096-01 LWD 3025G Triplex Plunger Pump Complete (6.5hp) Qty. 1 1 Pump Repair Kits 221-00310-01 Check Valve Kit, All LWD Series Pumps 1 221-00300-01 Piston Kit, All LWD Series Pumps 1 221-00302-01 Seal Kit, All LWD Series Pumps 1 Comet ZWD Pumps Select 11hp & 13hp units 1 Ref.
Operator’s Manual Page BURNER MODULE “Small” BLK RED WHT BLK BLOWER “Big” RED IGNITOR XFMR yellow - N.O.
Operator’s Manual Page 10 troubleshooting problem Low Water Pressure cause Insufficient water source Old or incorrect nozzle Plumbing or hose leak Obstruction in spray nozzle Chemical valve open Unloader valve worn Pump valves dirty or worn action Check hose size/water source Replace nozzle Tighten, repair or replace leak Clean or replace nozzle Close valve or submerge hose Replace unloader
Operator’s Manual Page 11 WARRANTY MANUFACTURER LIMITED WARRANTY ENGINES Honda GC Series Engines; ONE Year from date of purchase Honda will repair or replace any manufacturer defect at their expense. To be handled directly by Honda Service Centers. See owners manual for details. Honda GX Series Engines; TWO years from date of purchase Honda will repair or replace any manufacturer defect at their expense. To be handled by Honda Service Centers. See owners Manual for details.
