Instruction manual

Mini Amazing Box II
20
Installation Introduction
FAQs
File FormatsMain ScreenColor Editor
Quick Start
3. Click OK to enter the program. The design
transfer screen offers you a Read, Load, Save
and three Write Card buttons. The main screen
also has Delete, Options and Exit buttons. The
Load, Write Card and Delete buttons remain
inactive until a design has been read into the
software or a card inserted into the slot.
1. Make sure The Mini Amazing Box II has power.
To do this, simply verify the green light on the front
of The Mini Amazing Box II is on.
2. Open the Mini Amazing Box II program by
double-clicking on the icon. Make sure you have
only opened the program one time. When you
double click the icon, it takes a few seconds for
the program to open.
You must only have the program opened one
time in order to set up communication between
your computer and the Mini Amazing Box II.
General Operation
To ensure the program has opened, look at the
bottom of your monitor screen between the
“Start” button on the left and the clock on the
right. You should see a square with “Convert”
and a picture of the box. If you see more than
one of these, exit all except one and continue.
Warnin
g
Tip