Instruction manual

Installation
11
Installation Introduction
Quick Start
Main ScreenColor EditorFAQs
File Formats
If you get a message on your screen saying, “No
COM port...” this usually means the USB driver is
not installed correctly. Follow the following steps
to reinstall the driver.
1. Unplug the USB cable from the computer
while it is on.
2. Turn off your computer.
3. Plug the USB cable back into the computer.
4. Turn on the computer.
5. A Mircrosoft message stating, “New hardware
found,” appears.
6. Insert the Mini Amazing Box II CD into the CD-
ROM drive and cancel installation if it autoruns.
7. Now follow the on-screen prompts and
directions in the Installation chapter on Hardware
Installation to install the USB driver.
No COM port Error Message
Section4Install.pmd.P65 8/4/2004, 11:28 AM11