Installation Guide

LED Wall Scone
ASSEMBLY & INSTALLATION INSTRUCTIONS
Please read carefully and save these instructions, as you may need them at a
later date.
CAUTION
Turn off the main power at the circuit breaker before installing the fixture
in order to prevent possible shock.
GENERAL
All electrical connections must be in accordance with local and national
electrical code (N.E.C) standards. If you are unfamiliar with proper
electrical wiring connections obtain the services of a qualified electrician.
Remove the fixture and the mounting package from the box and make sure
that no parts are missing by referencing the illustrations on the installation
instruction.
ASSEMBLY AND INSTALLATION
1. Pull the acrylic lens out (11)from the fixture body.
2. Pull the supply wires (2&8) and the house ground wire (5) out from
the outlet box (1).
3. Make the wiring connections: connect the white supply wire (2) to the
white fixture wire (4); connect the black supply wire (8) to the black
fixture wire (7); connect the house ground wire (5) to the fixture
ground wire(6)using wire connectors (3).
4. Carefully tuck all wires back into the outlet box (1). Locate the fixture
Pan (12) over the outlet box (1). Put the mounting screws (10) through
the slots on the fixture pan . Then secure the mounting screws into the
outlet box tightly.
6. The Driver and LED board are combined, to replace or install, Use the
quick connector to replace . Do not exceed the recommended wattage
shown on the caution label.
7. Put the acrylic lens over the fixture body by sliding into the edge of the
fixture pan (12).
INSTALLATION IS NOW COMPLETED