User guide
Table Of Contents
- Introduction
- Hardware setup
- Connection to AMARI UE Simbox
- LTE service
- Initial setting
- Create scenario using WebGui
- Run UE scenarios with WebGui
- Create scenario without WebGui
- Downlink and Uplink transfer using iperf
- NB-IOT devices
- Channel simulator
- logging
- Advanced options
- Troubleshooting
Chapter 6: Create scenario using WebGui 19
Max simultaneous connected UE
Maximum number of simultaneously connected UE. Simulation will avoid any power
on until this limit is reached, in other words, next power on will occur after new
power off.
Power on duration
Duration in seconds of power on period. UE will remain powered on during this
time and them will power off, allowing a new UE to connect.
Power off duration
Minimum duration in seconds of power off period. When powered off, a UE will
remain powered off at least this time before being candidate to power on again.
Note: UE simulator will try to put as many simulation as possible within the duration
period, depending on parameters.
6.2.5 Simulations tab
The simulation tab aims to create different type of IP traffic simulation. You can add several
simulations per scenario. Each simulation will be placed inside each power on period of each
UE.
Click on "+" button and select simulation type:
You can then choose the following IP traffic:
ICMP Ping Perform ICMP Ping request.
UDP Send UDP constant bitrate traffic.
RTP Send RTP constant bitrate traffic.
VOIP Simulate voice RTP traffic using statistical model.
Flood Send UDP packet burst
HTTP transfert
Send HTTP requests.
Application
Launches an external application. See [External application], page 43, for more
details