User guide
Table Of Contents
- Introduction
- Hardware setup
- Connection to AMARI UE Simbox
- LTE service
- Initial setting
- Create scenario using WebGui
- Run UE scenarios with WebGui
- Create scenario without WebGui
- Downlink and Uplink transfer using iperf
- NB-IOT devices
- Channel simulator
- logging
- Advanced options
- Troubleshooting
Chapter 6: Create scenario using WebGui 16
Once the server client is created and get connected to the LTE UE service, a new window
will appear where logging level per layer can be set
For more details about logging configuration, see ltewww.pdf documentation
Note : If this page can’t be loaded, please check that lte service is running (service lte
status)
You should see now (as shown in the picture below)
• A yellow lightning icon on left panel
• Two new tabs on on center panel: UE Scenario & UE Simulator
.
UE Scenario will be used to define scenarii.
UE Simulator aims to control your UE simulator instance.
6.2 Create scenario
Once the webGui is up and running, you can create scenarios.
• In the main panel, click on the UE Scenario tab.