User guide
Table Of Contents
- Introduction
- Hardware setup
- Connection to AMARI UE Simbox
- LTE service
- Initial setting
- Create scenario using WebGui
- Run UE scenarios with WebGui
- Create scenario without WebGui
- Downlink and Uplink transfer using iperf
- NB-IOT devices
- Channel simulator
- logging
- Advanced options
- Troubleshooting
Chapter 2: Hardware setup 6
When rx_antenna: "rx" is set, RF connection is the same as for FDD. See section 2.2.3 for
more details about rx_antenna: "rx"
2.2.5 RF connection for one Cell MIMO 4x4 in FDD mode
In the case of MIMO 4x4, two SDR cards are required on the UE simulator side. Both SDR
cards are combined in order to provide four TX and RX antenna ports.