User guide
Table Of Contents
- Introduction
- Hardware setup
- Connection to AMARI UE Simbox
- LTE service
- Initial setting
- Create scenario using WebGui
- Run UE scenarios with WebGui
- Create scenario without WebGui
- Downlink and Uplink transfer using iperf
- NB-IOT devices
- Channel simulator
- logging
- Advanced options
- Troubleshooting
Chapter 2: Hardware setup 5
When rx_antenna: "rx" is set, RF connection is the same as for FDD.
2.2.4 RF connection for two Cells MIMO 2x2 in TDD mode
As for FDD, in the picture below each eNodeB cell uses a different antenna port (RF#1 and
RF#2). This configuration can be used for 2 neighbor cells or for a Carrier Aggregation test.
When both cells are using the same eNodeB antenna port, please refer to second picture (one
eNodeB antenna port) for the RF connection.