User Guide

2
2 Hardware setup
2.1 Power supply
Plug the external power adapter provided with the callbox in the DC-in Connector located in
the right corner of the rear panel and press the Power on button on the front panel to turn it
on.
Power adapter specifications:
Input: 100~240 V AC, 50~60 Hz, max. 2.5A
Output: Output: 19.5 V DC, max. 9.23 A, max. 180 W output wattage
2.2 Sim card
The callbox is delivered with a test sim card that is already provisioned in the EPC database.
No additional configuration is required for authenticating devices using this SIM card.
SIM card specifications:
• IMSI: 001010123456789
• K: 00112233445566778899aabbccddeeff
• sim algo: XOR
• Non programmable USIM card
• Support both 1.8V and 3V voltage.
 
It is possible to use and provision different SIM cards for your testing. In that case please
See [Provisioning of new SIM cards], page 9, for more details
 
2.3 Wireless RF connection
When running test over the air, connect the four LTE antennas provided with the callbox to
the SMA connectors (TX1, RX1, TX2, RX2) located on the rear panel of the callbox.
2.4 Wired RF connection
When running test in conducted mode, first thing to do is to connect the callbox correctly to
the device as described in the following sections.
Each SDR card has two RX and two TX SMA connectors plus one GPS connector.
• Rx1 is the main receive antenna port.
• Rx2 is the diversity receive antenna port.