User's Manual
1.1.1.1.1 AMANTYA TECHNOLOGIES
Doc. No : AMANTYA-v1.0
Release Date: 01-10-20
NBIoT Agnostic ACP User Manual Page 13 of 23
5 Test Case execution
5.1
Test execution
Note: Below is sequence of execution of test setup.
1. Run System simulation binaries (VZW_SA_Agent and NBIoT eNodeB L1L2 stack).
2. Test Cast tool setup with TTCN project
3. Run test case from Test Cast
4. Run System Adapter
5.1.1 Test execution with ACP <TBD>
5.1.2 Test execution without ACP
TTCN3 is a third‐party software provided by Elvior. Test cast software is basically a TTCN3 script
execution tool. It provides following functionality:
• It includes all the UE conformance test cases as specified by 3GPP
• It provides NAS and RRC codecs to support the Test cases
• It controls the UE using AT Command and ADB command
• It configures and bring the eNodeB up
• It provides the functionality of RRC Layer and NAS Layer emulation using the codecs as
• mentioned above
• It supports impairment for RRC and NAS messages to handle negative scenarios as
• mentioned in Test case
• Test Cast software sends and receives all messages in TCI‐XML format
When a Test case execution is requested, Test Cast starts cell bring up procedure as per the precondition
mentioned in Test case. Once the cell is up it starts test case execution and on completion it provides the
verdict.
Test case execution steps:
1. Open Test Cast tool
2. Select project from list of projects above.