User Manual

12

OPERATION
Thefireplacecanbeoperatedeitherbytheswitcheslocatedontheleftfrontofthefireplaceunitor
bysuppliedremotecontrol.
MANUALOPERATION



1. ThemainpowerON/OFFswitchinpositionO,thefireplaceisOFF.
2. WhenmainpowerON/OFFswitchisatpositionI,thefireplaceisreadytouse.
3. Pressthe buttonrepeatedlytosettheheatertodesiredheatsetting.Theheaterindicator
LEDwillglowwhichshowsthecurrentheatersettings.
a) RED1500WHEATOUTPUT
b) BLUE750WHEATOUTPUT
c) PURPLEAUTOMODE
AUTOMODE
UnderthismodetheheaterwillautomaticallyturnONathighheatsetting1500Wheatoutputwhen
theroomtemperaturedropsbelow22℃(72℉).Whentheroomtemperatureisbetween22‐
25℃(72‐77℉)theheateroutputwillswitchtolowheatsetting750W.Whentheroomtemperature
goesabove25℃(77℉)theheaterwillbeturnedoffandthecyclewillcontinue.TheLEDindicator
willbePURPLEincolourunderthismode.
4. Flameeffect:Pressthebuttonmarked toadjusttheflamebrightness.Theflamebrightness
willcyclethrough–Low‐Medium‐High‐OFF.
5. Moodlighteffect:Pressthebuttonmarked tochangethemoodlightcolour.

NOTE: IfoperatedattheLowheatsetting,thefireplacewillnotprovideasmuchheatoutputasin
theHighheatsetting,howeverthelowsettingwillnotrequireasmuchelectricalpowertooperate.
Toavoidoverloadingacircuit,donotplugthefireplaceintoacircuitthatalreadyhasother
appliancesworking.Whenthefireplaceisnotinuseswitchoffandunplug.

SAFETYCUT‐OFF
 Thisapplianceisfittedwithasafetycut‐offwhichwilloperateifthefireplaceoverheats(eg.Due
toblockedairvents).Forsafetyreasons,thefireplacewillNOTautomaticallyreset.
 Toresettheappliance,disconnecttheappliancefromthemainsupplyforatleast10minutes.
Reconnectthesupplytothemainandswitchontheappliance.