INSTALLER: LEAVE THIS MANUAL WITH THE APPLIANCE. CONSUMER: RETAIN THIS MANUAL FOR FUTURE REFERENCE. INSTALLATION AND OPERATING INSTRUCTIONS CERTIFIED UNDER CANADIAN AND AMERICAN NATIONAL STANDARDS: CSA C22.2 No.
QUICK REFERENCE GUIDE I. II. III. Prior to installation, please ensure: 1. The rated voltage of your firebox fits the output voltage of your outlet; 2. The light bulbs in your firebox are in good condition. Please follow the instructions for replacing the light bulbs in MAINTENANCE section of manual. The heater on your fireplace may emit a slight, harmless odor when first used. This odor is a normal condition caused by the initial heating of internal heater parts and will not occur again.
IMPORTANT INSTRUCTIONS WARNING You should read and always follow the important instructions below to reduce the risk of fire, electric shock, and injury to persons. 1. Read all instructions before using this fireplace. 2. This fireplace is hot when in use. To avoid burns, do not let bare skin touch hot surfaces, such as surfaces near the heater outlet or light bulbs. The grill directly in front of the heater outlet becomes hot during heater operation.
23. The heater must not be located immediately below a socket-out. 24. WARNING: In order to avoid overheating, do not cover the heater. 25. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. 26.
INSTALLATION This section provides step-by-step instructions for installation of your fireplace. WARNING The outlet must be 15A/120V. CAUTION Do not remove the four rubber feet at the bottom of the fireplace insert or install the fireplace insert directly on soft surfaces, which may restrict air circulation. Otherwise, it may cause a risk of fire or damage. 1.
OPERATION This section will explain the function of each convenient control. NOTE The heater may emit a slight, harmless odor when first used. This odor is a normal condition caused by initial heating of internal heater parts and will not occur again. • Control Panel Operation A.
button will turn it off. Similarly, pressing the button will switch the heater to high-power status when is dark, and turn it off when is illuminated. Note, before the heater emits heat or after it stops producing heat, the hot air outlet may output air for 10 seconds. This is a pre and post purge and is a normal function of the appliance. 4. Power off the electric fireplace when not in use. 5. The two alkaline batteries must be removed from the appliance before it is recycled. 6.
MAINTENANCE WARNING Disconnect power before attempting any maintenance or cleaning to reduce the risk of fire, electric shock to persons or damage. Light Bulb Replacement Light bulbs need to be replaced when you notice a dark section of the flame or when the clarity and detail of the log exterior disappears. There are two bulbs under the log set for 33P and four bulbs for 39P. WARNING Allow at least 5 minutes for light bulbs to cool off before touching bulbs to avoid burning of skin. I.
This marking indicates that this product should not be disposed with other household wastes. To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material resources. To return your used device, please use the return and collection systems or contact the retailer where the product was purchased.
Amantii Imports Corp. (“Amantii”) warrants that your newly purchased Amantii electric fireplace is free from manufacturing and material defects for a period of one (1) year from the date of the first purchase, subject to the conditions and limitations contained below.
www.amantii.
