Installation and Operation Guide

TS-3000i Web Clock Installation & Operation Guide 5-13
TS-3000i Menu Selections
With the TS-3000i Utility open, from the main menu use the buttons,
and/or perform the following functions, if necessary.
Menu Buttons
 Start TS-3000i discovery – Use this
button (if active) to restart
(rerun) the auto discovery, and generate a new list.
 End TS-3000i discovery – Use this
button (if active) to stop
the auto discovery.
 Save Settings – Use this
button to save the settings you have
defined on the Settings tab for Domain Name and Clock Discovery
Timeout. This information will be saved in ts-3000i_config.INI file.
 Print clock information – Use this
to print to your default
printer a list of all discovered TS-3000i clocks with the IP address,
MAC address and name.
File Menu Functions
 Refresh – Use this function for quick start/stop restart (rerun) the
auto discovery, and generate a new list.
 Reset Status – Use this function to reset (refresh) the displayed
status column after performing an update. This command always
resets the status to Ready, Updated (configuration or firmware
updated), and Failed (configuration or firmware update failed).
 Exit – Use this function to close the TS-3000i Utility.
View Menu Functions
 Settings – Use this function to enter discovery settings for Domain
name to allow discovery in multiple domains. Also, set clock
discovery timeout of TS-3000i Utility function. Domains can be
deleted from the list to browse (see Figure 5-14).