Installation and Operation Guide

TS-3000i Web Clock Installation & Operation Guide 4-17
Note
– The only editable field for a predefined time server is
Enabled, but if the time server was user created
, then the
Name, Host Name/IP Address, and Enabled fields can be
changed.
The Last Successful Sync and Last Successful Attempt
fields are read only. The last successful sync represents the
date/time that the clock time was actually synced (met
parameters), while the last successful attempt represents when
the actual connection attempt was successful.
Step 4. Click on the
button to create a user defined time server,
and the Time Server Settings screen will appear (see Figure
4-13). Enter the Name of the time server (maximum length is
20 characters).
Important – The acceptable characters for a Time Server
name are ‘a-z’ upper and lowercase, ‘0-9’, (-) dash, (_)
underscore, and (*) asterisk.
Look
– This is where you can setup the parameters to use an
internal Time Server. Also, when you create a new Time Server
it will automatically be placed at the top of the list in position 1.
This order is important because the first Time Server
successfully used sets the time.
Figure 4-13: Time Server Settings