Installation and Operation Guide

2-16 TS-3000i Web Clock Installation & Operation Guide
Seconds must be selected to be printed for this error message to be
seen. Seconds = default setting.
Acceptable Print Media
Print Media is defined as the type of material you will be using in the
machine to time stamp (time cards, documents, etc.). To avoid damaging
the print head, it is recommended that you do not exceed a media
thickness of 0.3 mm (0.01"). The following are general specifications for
the different media dimensions.
 Time Card: Time card thickness less than or equal to 0.3 mm
(0.01").
 Small Ticket: Tickets, slips, receipts or other validation media
should be no smaller than 100 mm (4”) long x 60 mm (2.25") wide.
 Larger Paper: When using standard paper sizes, such as 8.5" x 11",
make sure the paper is heavy enough to push the Paper Sensor. If
the weight of the paper (thickness) is too light, the paper will curl up
and tear off inside the TS-3000
i Web Clock. This may result in jams
or damage to the clock.
 Carbon Paper: The TS-3000i Web Clock will print on both carbon
and carbonless paper. The imprint will print through up to six copies,
depending on the quality of the document used. Carbon and
carbonless paper deteriorates over time. Humidity, high
temperatures and sunlight accelerate this process. For maximum
print performance, use only high grade, uncontaminated carbon or
carbonless paper.
Adjusting the Print Margin
If you wish to change the default margin adjustment, locate the Margin
Selector on the bottom of the machine and slide in the direction of the
arrows to adjust the print margin (see Figure 2-17).
This selector will move the Paper Sensor forward or backward on the
Printer Platen and determine how much of a margin there is between
the imprint and the edge of the print media. The margin can be adjusted
to a maximum of 30 mm (1.2").