Installation and Operation Guide

TS-3000i Web Clock Installation & Operation Guide 7-9
In addition to the flashing day indicators, during the print cycle, the clock
will print a block (█) instead of an “s” at the end of a print line to indicate
that this failed time sync condition has occurred (see the following
example).
Print Example = 2008/07/08 18:30 15█
Seconds must be selected to be printed for this error message to be
seen.
Error Messages
In the event of an error, a message will appear in the display. The
possible error messages are listed in the following Table along with their
probable causes and solutions.
Note – An error message can be cleared by removing the
cover and pressing the “Reset” button (see Figure 7-9). The
Reset button will NOT clear the configuration and/or transaction
information (i.e., DST & print line styles) stored in the clock
flash memory. Conversely, it is not recommended to clear an
error by using the Reset command from the clock web interface
as this could reset the clock configuration.
Figure 7-9: Reset Button Location