Installation and Operation Guide

TS-3000i Web Clock Installation & Operation Guide 7-7
Display Messages
Normal Startup
When the AC power is connected to the clock, the display on the clock
will flash “boot”, then sequentially display the complete IP address twice,
and finally show the normal display of date and time. See the following
figure for an example.
For TS-3000i with no network connection
During the clock power up sequence, if the clock cannot make a network
connection, it will flash 0.0.0.0 for the IP Address. If this happens, please
verify that the clock is connected.
Colon Status
For TS-3000i equipped with FPR Option Only
If the AC power is connected to the clock, the display colon will “flash.”
Upon loss of AC power, the display colon will remain constant to indicate
that the clock with printing capability is currently running from the battery
which has a 6 hour or 400 print cycle capacity.
For example, an
IP = 192.168.57.106
would display
1
st
192
2
nd
168
3
rd
57
4
th
106