User manual

Time Guardian v4.0 User’s Guide 4-35
• Access Tries:
•
The number of times a user can attempt to use the terminal before being
rejected.
ID Length:
•
The field length of the User or Employee ID.
Reject Threshold:
The sensitivity of the terminal to the employee’s hand geometry. The
default value is 125, but it can be set to a value between 30 and 250. A lower number
indicates high sensitivity.
Terminal Tab - Clock
The Terminal tab is used to manually add or remove terminals in a Location, and assign Bell
and Door Schedules to terminals. Each terminal in an Location is defined by its terminal
number.
1. Click on the New
To add a terminal:
button.
2. Select a Location from the Location List
3. Enter the terminal number in the Terminal Number field. The terminal number is the same
as the address assigned to the terminal during installation. Valid values are 1 through 31.
Each location may have up to 31 terminals connected together in a “daisy chain”. Refer to
your terminal’s specific documentation for assigning addresses and network connections.
Note: Terminal number MUST BE '0" for HandPunch Ethernet terminal.
4. If you wish to assign a Relay or Door Schedule to a terminal, select one from the dropdown
list.
5. Click on the Save button. The terminal number will appear in the Terminal List and a
terminal icon will be placed underneath the Location in the Location List.