Specifications

FPT-40 Installation & Operation Guide Page 3-5
Figure 3-4 Software Setup for Locations
Before a Location can be created, a Bell Schedule (optional) and
Terminal Validation list should be setup.
You may have to create a Location to communicate with your FPT-40
terminals. A Location enables the Time & Attendance software to
distinguish and interact with the desired terminal(s). Only one terminal
type can be used per Location. If you have more than one terminal type
[i.e, FPT-40 and MTX-15], you must have multiple Locations.
If you are configuring a direct connect serial FPT-40 terminal, you may
have to determine the PC Comm port that the USB CommStik is
connected to and select it in Connection tab from the Locations screen
(see Figure 3-5).
The window will open on the General tab with a default Location Name.
It is recommended to use the “FPT-40 Default” name.