Specifications

FPT-40 Installation & Operation Guide Page 2-43
 Dev Num: The default is "1". The range is 1 to 255. The device
number is unique for each terminal. If there are two terminals with
the same number in the network, they will not work properly and
Time & Attendance software will be confused when polling the
terminals.
 IP Addr: The default is "192.168.1.201". The IP address for the
terminal must be unique in the LAN.
 Net Speed: The network default speed is "AUTO". The other
choices are: 10M-H, 100M-H, 10M-F and 100M-F.
 Net Mask: The default is "255.255.255.0". The subnet mask must
be consistent to the LAN IP address of the device.
 Gateway: The default is "0.0.0.0". If Gateway and Net Mask are not
defined, Ethernet will not be active.
 Ethernet: select "Y" or "N" for Ethernet TCP/IP communications.
This option must be set to (Y)es to utilize Ethernet.
 RS232: select "Y" or "N" for RS232 serial communications.
 RS485: select "Y" or "N" for RS485 serial communications
[used for transmission distances over 50 feet].
 COMM Key: The default is "0". The range is 1 to 999999. This
function is not used.
To set communication options:
1. Press the Menu button and select Options (see figure).
Menu
User Mana
g
e
Options
Sys Info
Figure 2-105 Select Options
2. Press OK to display Options menu and select Comm Opt
(see Figure 2-106).
Options
System Opt
Power Mng
Comm Opt
Figure 2-106 Select Comm Opt