Specifications

Page 2-4 FPT-40 Installation & Operation Guide
Punching with a Fingerprint (FP) and Password (Pwd)
1. From the Welcome screen either place your finger on the sensor or
enter your assigned User ID using the keypad.
2. Follow the on screen prompt to remove finger (see figure)
or input
your password.
Figure 2-7 Remove Finger
3. Upon verification, the screen will display your Name, User ID, and
the confirmation "Verified." with the voice prompt "Thank you"
followed by the momentary display of your hours worked for the
active pay period.
Note: The advantage of being enrolled as a user with a fingerprint
template and password is that you can use either method to
punch. This provides an automatic backup should you
encounter any problems with fingerprint validation. Therefore,
the first method used and accepted is the only method you
need to validate a punch.
Enrolling Users at the FPT-40 Terminal
After installing the FPT-40 Fingerprint terminal and powering on, you
may begin enrolling users. If this is the first enrollment in a new or empty
system, everyone will be able to enroll. However, if there are any users
with privileges already setup in the system, you will have to be enrolled
by a user with privileges. The FPT-40 fingerprint reader provides the
following three methods for enrollment; fingerprint, password, or
fingerprint and password [in this instance the 1
st
method submitted and
accepted is used].