Specifications

FPT-40 Installation & Operation Guide Page 1-9
FPT-40 Startup Welcome Screen (Power On)
Once the terminal is wall mounted and the communication connections
have been made, connect the terminal to AC power (see Figure 1-6) and
power on to setup and enroll users.
DC/6V
Ethernet
Serial (DB9 to
USB CommStik
)
AC Power
Back Plate
Retaining Screws
Figure 1-6 FPT-40 Fingerprint Terminal Bottom View
To start-up perform the following:
 Ensure the AC Power Adapter is connected to the FPT-40 terminal
and plugged into an outlet. Press the power
 button. The FPT-40
terminal will display the splash screen, perform a diagnostic check,
and then display the Welcome screen (see figure).
Figure 1-7 Welcome Screen
Note: The time and date can be set with the terminal keypad, or
downloaded to the terminal from the host PC utilizing the Time
& Attendance software. The information such as date, time,
daylight saving time (DST), finger templates, and hours
worked sent from the Time & Attendance software will have
precedence over existing similar information. That is to say the
Time & Attendance software will act as the master.
 Upon power up, the Green LED indicator will blink once every
second to signify the terminal is operating properly. The FPT-40
terminal should now be ready to enroll users.
 All normal time and attendance functions (validation for punch in/out)
must be performed from the "Welcome" screen.