Specifications

FPT-40 Installation & Operation Guide Page 1-5
Figure 1-2 Back Plate For Wall Mounting
2. Using the back plate as a template, mark the location of the upper
mounting holes on the wall. Mark a vertical line on the wall as a guide
to align the lower mounting holes.
Note: Pay attention to the orientation. The back plate should only be
mounted one-way as it is keyed to fit into the back of the
fingerprint reader.
3. Install a screw or anchor at the mark and hang the back plate from the
top-mounting holes. Level the back plate by centering the vertical line
in the bottom holes.
4. Mark the location of the bottom holes.
5. Install the screws or anchors for the bottom-mounting holes and
secure the back plate to the wall.
6. Insert the back of the fingerprint reader onto the four (4) retaining
tabs. The tabs are keyed to accept the fingerprint reader only one
way! Secure the reader to the tabs by inserting and tightening the 4
retaining screws.
7. Your fingerprint reader is now mounted to the wall and ready to
connect the data and power lines. After wall mounting, remove the
dustproof film on the sensor window. Proceed to the next section,
Communication Connections.