Specifications

Page 1-4 FPT-40 Installation & Operation Guide
Wall Mounting
Warning! Before selecting a mounting location for your FPT-40
Fingerprint terminal, you must consider the following:
 The mounting surface and hardware must be able to support the
unit’s weight, 1.35 lbs. (0.61 kg).
 The area must be within the specified operating temperature &
humidity range (see Specifications on page 4-11)).
 The FPT-40 Fingerprint terminal should be mounted in an
environment that avoids the conditions pictured in the following figure:
 Close proximity to a wall outlet ( 6 ft), and a wall that can
accommodate signal and/or power conduits.
 If using Ethernet, close proximity to an Ethernet connection (
 6 ft).
Amano recommends the following wall mounting procedure:
1. Loosen and remove the four (4) back plate retaining screws to
remove the back plate as shown (see Figure 1-2). Set the FPT-40
terminal face up on a flat surface.