Operation Manual

PIX-75 www.amano.com/time  1-800-253-9836 6

Remove the Cover & Packing Material

1. Insert the key provided into the keyhole on top of the clock, turn

clockwise ¼ turn to unlock the cover and lift the cover to remove (see

Figure on previous page).

2. Remove the

cardboard spacer

located above the

ribbon cartridge by

pulling straight out

(see right-hand

Figure).

3. Lift up the printer

carriage by placing

your fingers under the

metal motor on the

left-hand side and

remove the foam

spacer (white) located

under the print head

(see right-hand

Figures). Release the

printer carriage.

4. After removing the

foam spacer with the

cover off plug in the clock!

Note –Should the clock not power up, verify that the AC Adapter is

plugged into the rear of the clock. See Figure 4 on page 41 and

Figure 5 on page 44 for AC Adapter plug-in location.

Note – If your TCX-85 is located in an area that cannot receive the

Atomic time signal, DO NOT be concerned. The TCX-85 will

accurately keep the time using its Quartz mechanism (plus or minus

three seconds per week).

When you first receive the clock, it may be necessary to adjust the

time so the test printout may not show the accurate time.