Operation Manual

PIX-75 www.amano.com/time  1-800-253-9836 46
Internal View
The 4 function buttons are used to navigate through the Setup Mode to
change the clock’s settings.
 The PROGRAM button is used to enter/exit the Program Mode and exit any
sub-program menu.
 The + and - buttons are used to change the information on the display
through programmable areas and possible inputs. By pressing and
releasing these buttons, the selectable option will be displayed or the
number values will be increased or decreased by 1. These buttons (see
illustration on previous page) can be pressed and held for 3 seconds or
greater for faster change.
 The ENTER button is used to accept the information shown on the display
and save it in memory.
 The RESET button will restart the clock with no change to user settings,
time, and ink capacity.
Need Ribbons, Keys and Accessories?
Visit
www.amano.com/time
Or call 1-800-253-9836
The Atomic Time Synchronization Indicator in the
LCD Display indicates the status of the signal. When
you first receive the clock, it may be necessary to adjust
the hour and minute. This Atomic Time
Synchronization feature is not available in Hawaii
and Alaska.
Whenever the time is changed on the clock by the user the “Signal Found”
Atomic Time Synchronization Indicator will be turned off and just the
“Searching for Signal” indicator will be displayed. The clock will automatically
resynchronize the time (minutes and seconds) by searching for the Atomic
Time signal.
Note – The atomic clock feature must be enabled for this time
synchronization process. Amano recommends facing the front of
the clock (display side) either in a South or North direction to
increase potential atomic time signal reception.