Operation Manual

PIX-75 www.amano.com/time  1-800-253-9836 32
After replacing the cover, the display for the bottom
line day will change. The right-hand day character
will either show; E, O, or 1 (see right-hand figure
example).
E = error (something interrupted the signal)
O = Low signal strength
1 = High signal strength
The display will continue doing this until Code 12 is entered from P705
ADVANCED to disable the atomic clock diagnostic.
 Atomic Clock Diagnostic OFF (Code 12)
By entering code 12, the clock turns off the diagnostic mode for the
atomic clock sync data. The clock displays the message “DEBUG OFF”.
When the clock displays P705 ADVANCED, press the PROGRAM
button and then proceed to step 3 above to continue with diagnostics or
press the PROGRAM button again to return the clock back to normal
operation.
 Reset Settings to Factory Defaults (Code 32)
By entering code 32, the clock resets all user settings (except the time,
date, and ink count) to the factory defaults settings. The clock displays
the message “WAIT” and “RESET” on the LCD screen and restarts.
 Show Total Prints (Code 88)
By entering code 88, the clock will display the total number of prints the
TCX-85 clock has printed since it was manufactured for several seconds.
This count cannot be reset.
When the clock displays P705 ADVANCED, press the PROGRAM
button and then proceed to step 3 above to continue with diagnostics or
press the PROGRAM button again to return the clock back to normal
operation.