Operation Manual

PIX-75 www.amano.com/time  1-800-253-9836 31
2. Press the + or – button to change the current programming mode until
the display shows P7 DIAGNOSTICS.
3. Press the ENTER button once and the clock will display the sub menu
P701.
4. Press the + or – button until the display shows
P705 ADVANCED.
5. Press the ENTER button once to enter the
diagnostic mode. The clock will prompt the user to
enter a 2-digit code by first flashing the lefthand digit
on the bottom line. Change the first digit of the code using the + or –
button until the display shows the correct code number in the left-hand
digit.
6. Press the ENTER button once and repeat the same function to select the
right hand digit, then press the ENTER button once to perform the
diagnostics for the codes listed below.
NOTE:
 Invalid Codes
By entering any other code than mentioned, the
clock will display a message “ERROR” and go
back to the previous menu without performing
any action. Press the PROGRAM button and
the clock shows P7 DIAGNOSTICS. Repeat steps 3, 4, and 5 above
and enter the correct code.
 Atomic Clock Diagnostic ON (Code 11)
By entering code 11, the clock turns on the diagnostic mode for the
atomic clock sync data and displays the raw data received by the atomic
clock receiver chip on the bottom line of the LCD when it is trying to sync
with the atomic clock. The clock will briefly
display the message “DEBUG ON”.
When the clock displays P705 ADVANCED,
press the PROGRAM button and then proceed
to step 3 to continue with diagnostics or press
the PROGRAM button again to return the
clock back to normal operation.