Operation Manual

PIX-75 www.amano.com/time  1-800-253-9836 30
5. Press the ENTER button once and the clock will display the most
recent warning message. If there are no warning messages, the clock
will display the text NO MESSAGE.
6. Press the ENTER button once to exit and go back to the previous
menu.
7. Press the PROGRAM button 2 times to exit ALL programming or Press
+ to go scroll through sub menu options for P7 DIAGNOSTICS
again.
LCD Test (P704)
Use this diagnostic to check the TCX-85 LCD display by turning on all
segments.
1. With the cover removed, press the PROGRAM button to begin
programming mode and P1 TIME will appear.
2. Press the + or – button to change the current programming mode until
the display shows P7 DIAGNOSTICS.
3. Press the ENTER button once and the clock will display the sub menu
P701.
4. Press the + or – button until the display shows
P704 LCD TEST.
5. Press the ENTER button once and the clock will
start flashing each segment one at a time and will
end by displaying all of them at once.
6. Press ENTER button once to exit and go back to
the previous menu.
7. Press the PROGRAM button 2 times to exit ALL programming or Press
+ to go scroll through sub menu options for P7 DIAGNOSTICS again.
Advanced Diagnostics (P705)
Since the ADVANCED DIAGNOSTICS area is not intended to be
accessed by the casual user, the menu selection sequence is a bit different
than selections P701 - P704 above. Refer to each of the sections below
for the proper sequence to navigate through data entry.
1. With the cover removed, press the PROGRAM button to begin
programming mode and P1 TIME will appear.