Operation Manual

PIX-75 www.amano.com/time  1-800-253-9836 26
4. Press the + or – button until the display shows
P609 DLS BEGIN DATE. [The second line will
scroll]
5. Press the ENTER button once and the month will
start flashing. Press the + or – button to increase or
decrease the month value.
6. Press the ENTER button once to set the desired
month and go to the date setup mode.
7. The date will start flashing. Press the + or – button
to increase or decrease the date.
8. Press the ENTER button once to set the desired
date and go to the year setup mode.
9. The year will start flashing. Press the + or – button to increase or
decrease the year.
10. Press the ENTER button once to set the desired year and complete the
set DLS Begin Date mode and go to the previous menu.
11. Press the + button once to move to next menu for setting DLS End
Date.
Note – In order for the Daylight Saving Time feature to function
correctly, both Begin and End dates need to be programmed.
Changing End Date for Daylight Saving Time (P610)
Note – the government standard for Daylight Saving is subject to
change. Your clock is factory set for correct Daylight Saving based upon
when it was manufactured, but any revision to Daylight Saving beginning
or ending dates may require updating the system-set Daylight Saving
calendar. The default end date setting = November 2, 2014 at 2:00AM,
which is the first Sunday of November, 2014.
If the current year and date has been changed, the available daylight
saving start/end date will be automatically updated as well.
The TCX-85 during DLS advance/rollback at 2:00 AM will only shift 1
hour.
If the DLS feature is enabled and the user sets the same start/end dates,
the clock will not change its time on the start/end date.
The steps below change the end date for Daylight Saving. Updating the
ending date for Daylight Saving needs to be done just one time, since the
clock’s rolling calendar function will auto-calculate the end date for each year