Operation Manual

PIX-75 www.amano.com/time  1-800-253-9836 25
(see example right-hand Figure). However, if a
custom print format is defined for line 2 the
clock will display “LINE – 1” in the auxiliary
line to prompt the user that the first line will be
printed. After printing line 1, the clock will
display “LINE – 2” for 5 seconds to prompt
the user that line 2 is being printed (see
example right-hand Figure).
7. Press the ENTER button once to accept the
current displayed value and go back to the
previous menu.
8. Press the PROGRAM button 2 times to exit ALL
programming or Press + to go to the next program menu.
Changing Begin Date for Daylight Saving Time (P609)
Note – The government standard for Daylight Saving is subject to
change. Your clock is factory set for correct Daylight Saving based upon
when it was manufactured, but any revision to Daylight Saving beginning
or ending dates may require updating the system-set Daylight Saving
calendar. The default start date setting = March 09, 2014 at 2:00AM,
which is the second Sunday of March, 2014.
If the current year and date has been changed, the available daylight
saving start/end date will be automatically updated as well.
The TCX-85 during DLS advance/rollback at 2:00 AM will only shift 1
hour.
If the DLS feature is enabled and the user sets the same start/end dates,
the clock will not change its time on the start/end date.
The following steps change the begin date for Daylight Saving. Updating the
beginning date for Daylight Saving needs to be done just one time, since the
clock’s rolling calendar function will auto-calculate the beginning date for
each year thereafter. To change the end date for Daylight Saving, refer to
the next section.
1. With the cover removed, press the PROGRAM button to begin
programming mode and P1 TIME will appear.
2. Press the + or – button to change the current programming mode until
the display shows P6 OTHERS.
3. Press the ENTER button once and the clock will display the submenu
for other settings such as P601.